Ramsey Winch RPH 50000 UW/TNR & 2 SPEED MOTOR - Manual (Page 3)

RAMSEY HYDRAULIC PLANETARY WINCH MODEL RPH 50,000
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and
safety procedures one needs to know before operating a Ramsey Winch. Do not operate this winch until
you have carefully read and understand the "WARNINGS" and "OPERATION" sections of this manual.
WARRANTY INFORMATION
Rated Line Pull (lbs.).........................................................................50,000
18,550
8.6
40,900
Gear Reduction................................................................................51.35:1
dia. extra improved plow steel or equivalent
(Kgs.)..............................................................................22,670
1 2 LAYER OF CABLE
*Line speed
*Cable capacity
(at 25 GPM)
per layer
*Rated line pull
FPM
Kg.
Lbs.
MPM
M.
Ft.
9 19
7.0
23 28
22,670
50,000
30 65
3 4 5**
13,600
48
38
30,000
160
11.7
33
33
10.1
15,690
34,600
110
66
43
13.2
11,970
26,400
220
Weight (without cable).................................................717 lb. (325.2 Kgs.)
Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch
we make. If the need should arise, warranty procedure is outlined on the back of your self-addressed
postage paid warranty card. Please read and fill out the enclosed warranty card and send it to Ramsey
Winch Company. If you have any problems with our winch, please follow instructions for prompt service on
all warranty claims. Refer to back page for limited warranty.
SPECIFICATIONS*
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope
ratings.
WARNINGS:
VERIFY PROPER COUNTERBALANCE VALVE CARTRIDGE AND PLUG POSITION FOR SPECIFIC
INSTALLATION.
CLUTCH MUST BE TOTALLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE
LOAD. CABLE ANCHOR IS NOT DESIGNED TO HOLD LOAD.
1