Ramsey Winch RPH 50000 UW/TNR & 2 SPEED MOTOR - Manual (Page 16)

14. Apply Loc-tite to threads of nut #27 and thread onto setscrew #21 to 3/8 inch from drive end,
as shown below. Slide washer #26 over set screw until it rests against the nut. Apply Loc-tite to
threads of setscrew and thread insert #31 over end of setscrew and against nut. Use setscrew
and nut to thread insert #31 into end of air cylinder rod. Tighten nut against cylinder rod,
keeping 3/8 inch distance from drive end of setscrew to nut.
Pull rod from air cylinder as far as possible. Slide washer #25 over setscrew #20 and against
nut attached to air cylinder rod. Place setscrew into hole of shifter shaft #12 and attach air
cylinder to gear box cover using (4) capscrews #22. Apply Loc-tite PST thread sealer to
threads of capscrews. Torque capscrews to 5 ft-lbs. each, in criss-cross pattern. Note: port in
cylinder should be oriented to be accessible through slot in gear box cover.
12
21
26
27
39
34
37
31
23
15. Attach motor #40 with gasket #35b to brake #35. Use (2) capscrews #20 and torque to 74 ft.-lbs.
each. Securely connect tube #46 to elbow #32, in bottom of valve #47, and fitting #33 in bottom of
brake #35.
47
35
20
40
35b
20
46
14