Ramsey Winch RPH 50000 UW/TNR & 2 SPEED MOTOR - Manual (Page 10)

7. Remove output coupling #8 and coupling shaft #6 from end bearing #10. Examine bearings #13
pressed in output coupling for signs of wear. Replace bearings, if necessary, by pressing old
bearings from coupling and press new bearings into each end of output coupling. Place coupling
shaft into bearings.
13 10
13
6
8
8. Remove (12) capscrews #15 to pull gear-housing cover #4 and gasket #36 from ring gear #49.
Remove input thrust washer, sun gear and carrier assemblies from inside of ring gear. Remove
ring gear #49 and gasket #36 from end bearing #10. Examine shifter shaft #12 for signs of wear,
replace if necessary. Examine bushing #14 for signs of wear. Replace bushing, if necessary, by
pressing old bushing from housing and pressing new bushing into place.
49
36
4
48
36
10
12
14
15
8