Ramsey Winch RPH 50000 UW/TNR & 2 SPEED MOTOR - Manual (Page 12)

10. Gently tap key #5 into keyway of input shaft #11. Liberally apply grease to shoulder of input
shaft. Place 1-3/4 OD washer #28 over end of shaft and against shoulder of shaft. Place spring
#44 inside of spring #45 and place springs over shaft and against washer #28. Slide 2-3/8 OD
clutch washer #27 over splined end of shaft and against springs. Use grease to hold springs
and washers in place on shaft. Align keyway of coupling with key end of input shaft. Slide
coupling #7 over end of shaft #11. Slide entire assembly into journal of motor end bearing #9,
aligning key slot in #7 with key on brake shaft, until it bottoms out. Stand entire assembly
upright so that shaft and springs are vertical. Note: Wood blocks or other equivalent
support, under motor end bearing #9, should be used to stabilize assembly.
11
9
5
44
45
28
7
27
10