Ramsey Winch H-800 DOW-LOK W/25000 LB RATING - Manual (Page 15)

15
(16)
Press bearing (item #34) onto worm and into
housing. NOTE: Be sure that thick shoulder of
bearings outer race (side with manufacturer's
name and part number) is out, away from worm
threads. Attach bearing cap (item #8) to gear
housing using six capscrews (item #41) with
lockwashers (item #52). Tighten capscrews to
39 ft. lb. (52 Nm.) each. Insert key (item #24)
into keyway of worm shaft.
(17)
Press bearing (item #34) onto worm and into
housing. NOTE: Be sure that thick shoulder
of bearings outer race (side with manufactur-
er's name and part number) is out, away from
worm threads. Attach adapter (item #3) to
gear housing using six capscrews (item
#50). Tighten capscrews to 45 ft. lb. (61
Nm.) each. Insert key (item #24) into key-
way of worm shaft. Slide coupling (item #2)
over end of worm shaft. Attach adapter plate
(item #26) to adapter using eight capscrews
(item #48). Tighten capscrews to 21 ft. lb.
(28 Nm.) each.
Place motor shaft, with key in keyway, into
coupling. Secure motor (item #62) to
adapter, using two capscrews (item #51).
Tighten capscrews to 102 ft. lb. (138 Nm.)
each.
(17a)
Place thrust washers (item #74) and thrust
bearing (item #32) over end of worm (item
#28) and into housing. Attach adapter (item
#2) with gasket (item #54) to housing,
using six (item #47) capscrews. Tighten
capscrews to 45 ft.lb. (61Nm.) each.
Insert pilot seal (item #68) into adapter and
carefully place motor shaft, with key in key-
way, through seal, so as not to damage seal.
Insert motor shaft into end of worm (item
#28). Secure motor (item #59) to coupling
using two (item #48) capscrews with lock-
washers (item #52). Tighten capscrews to
102 ft.lbs. (138 Nm.) each.