Ramsey Winch H-800 DOW-LOK W/25000 LB RATING - Manual (Page 12)

12
(5)
Remove motor (item #62) from adapter plate (item
#26) by removing capscrews (item #51). Remove
adapter plate and coupling (item #2) from adapter
(item #3) by unscrewing eight capscrews (item
#48).
Remove key (item #24) from worm shaft.
Unscrew six capscrews (item #50) and remove
adapter from gear housing. Replace adapter seal
(item #70) and gasket (item #57).
(5a)
Remove motor (item #59) from adapter (item #2) by
removing two capscrews and lockwashers (item #48
& #52). Remove adapter (item #2) from gear housing
by removing six (item #47) capscrews. Replace pilot
seal (item #68) and gasket (item #54). Remove
thrust bearing (item #32) and thrust washers (item
#74).
(6)
Refer to page 5, SERVICING OIL COOLED SAFE-
TY BRAKE. Remove brake housing (item #18)
from gear housing by unscrewing six (item
#49) capscrews. Remove key (item #23)
from worm. Remove worm (item #30) and
bearings (item #34) from gear housing. Use a
soft hammer to gently tap input end of worm
and drive worm and bearing from gear housing.
Once worm has been removed from housing,
bearing can be pressed from end of worm.
Check for signs of wear or damage to worm
(item #30) and bearings (item #34). Replace if necessary.
(7)
Remove gear housing cover (item #12) from gear
housing (item #20) by unscrewing eight capscrews
(item #40). Thread two of the capscrews into the
two tapped holes of cover and tighten. This will pull
the cover loose from gear housing.
Remove cover gasket (item #58) and pull shaft (item
#27), with gear (item #17) and spacer (item #74)
attached, from gear housing.