Ramsey Winch H-800 DOW-LOK W/25000 LB RATING - Manual (Page 13)

13
(8)
Check for signs of wear on gear teeth. If necessary,
replace gear.
Check lube fittings (item #78) for damage and
replace if necessary. Remove lube fittings (item
#78) and reducers (item #62) from ends of shaft,
if following Step 9, and reinstall after Step 9.
(9)
If shaft and/or gear hub is damaged, replace as
follows:
a. Tap keys (item #25) into short keyways
of drum shaft (item #27).
b. Press shaft (item #27) and keys through
gear hub (item #17) until end of keys on
long end of shaft are flush with hub.
(10)
Check gear housing bushing (item #5) and o-ring (item
#63) for signs of wear. Replace if necessary by pressing
old bushing from gear housing (item #20). Press new
bushing into place and insert new o-ring (item #61) into
groove inside of bushing.
(11)
Check drum bushings (items #35 & #36) for signs
of wear. Replace if necessary by pressing old bush-
ings from drum (item #14). Press bushing (item
#35) into bore in drum until it's flange is seated
against bottom of counterbore. Press bushing (item
#36) into opposite bore on drum until end of bush-
ing extends .50" from end of drum.