Ramsey Winch H-800 DOW-LOK W/25000 LB RATING User Manual

Page 14

(12)

Check end bearing bushing (item #36) for signs of
wear. If necessary, remove old bushing and press new
bushing into place.

(13)

Check cover bushing (item #5) and o-ring (item #61)
for signs of wear. Replace if necessary by pressing
old bushing from gear housing cover (item #12).
Press new bushing into place and insert new o-ring
(item #61) into groove inside of bushing.

RE-ASSEMBLY

(14)

Slide spacer (item #74) over long end of
shaft and place against gear hub. Apply
grease to end of shaft, opposite gear. Apply
grease to bushing in gear housing (item #20).
Place greased end of shaft through bushing in
gear housing (item #20). Place gasket (item
#58) onto gear housing cover (item #12).
Apply grease to gear end of shaft and cover

bushing. Place cover onto shaft and secure to housing with eight (item #40) capscrews.
Tighten capscrews to 39 ft. lb. (52 Nm.) each.

(15)

Press bearing (item #34) onto worm
(item #30). NOTE: Be sure that thick
shoulder of bearings outer race (side with
manufacturer's name and part number) is
out, away from worm threads. Press
bearing and worm into gear housing. Slip
gasket (item #56) onto brake housing
(item #18). Use six capscrews (item
#49) to secure brake housing to gear
housing. Tighten capscrews to 45 ft. lb.
(61 Nm.) each.

Place key (item #23) into keyway of
worm (item #30). Refer to page 6 for
reassembly and checking of worm brake.