Poly-Tex FieldPro Gothic - Manual (Page 7)

FRAME ASSEMBLY
4
REV: AH-120507
1. ON THE MID-SECTION TUBE PLACE A MARK 15 5/8" FROM THE SWEDGE END OF TUBE.
THIS MARK IS FOR THE PURLIN AND PURLIN FASTENER LOCATION.
2. ASSEMBLE ENTIRE FRAME ON A FLAT SURFACE, OR BLOCK AS NECESSARY.
3. SECURE FRAME SECTIONS TOGETHER USING (2) 1/4"-14 X 1" SELF
DRILLING SCREWS INSTALLED AT EACH CONNECTION.
SEE FIGURE 1
4. ATTACH 4' STRIP OF FOAM TAPE TO PEAK SECTION.
5. CAUTON: DO NOT INSTALL SCREWS IN A POSITION OF THE TUBE WHERE THE
SCREWS WILL CONTACT THE POLY SHEETING COVER.
6. SEE PAGE 14 & 15 FOR TRUSS KIT INSTALLATION.
FIGURE 1
MID-SECTION
MID-SECTION
FOAM TAPE
STRAIGHT
SIDE
STRAIGHT
SIDE
1"
2"
NOMINAL
DIMENSIONS
15 5/8"
15 5/8"
PEAK SECTION