Poly-Tex KOOL HOUSE - Manual (Page 8)

ROLL
FORM
ROLL FORM
"L" BRACKET
FOR WOOD SIDE
RAIL APPLICATIONS
PLACE WOOD ON
OUTSIDE OF STRUCTURE
(2) 1/4" x 1 1/2"
LAG SCREW
HOOP
1.66" "U" CLAMP
#12-14 x 3/4" SELF
DRILLING SCREW
KOOL HOUSE
FRAME SECTION
(2) LONG
SPEED HOOKS
(2) 5/16" x 1 1/4"
CARRIGE BOLT,
LOCK WASHER
& NUT
1 1/2" VERTICAL
INSIDE VIEW
POSITIONING OF ROLL FORM
1 1/2" VERTICAL & HOOP ASSEMBLY
CORNER ASSEMBLY
VERTICAL ASSEMBLY
IMPORTANT NOTE:
IF THE RAIL EXTENDS BEYOND THE END
HOOP OF THE STRUCTURE, CUT THE RAIL
FLUSH WITH THE OUTSIDE EDGE OF THE
END HOOP. USE THE CUT OFF PIECE TO
BEGIN THE NEXT ROW.
NOTE: WHEN ANY PART OF THE OVAL INSERT IS TOO NEAR A
POST TO ATTACH UNI-CLAMPS, CUT A PORTION (8" - 12")
FROM THE PLAIN END OF THE ROLL FORM AND
PROCEED WITH THE INSTALLATION.
ROLL FORM
CONNECTION
ROLL FORM
SWAGE END
ROLL FORM
PLAIN END
#12-14 x 3/4" SELF
DRILLING SCREWS
#12-14 x 3/4" SELF
DRILLING SCREW
ROLL FORM
IMPORTANT: DO NOT TIGHTEN
WITH SCREW DRIVER. USE A 3/8"
SOCKET FOR MAXIMUM STRENGTH
1/4" X 1-1/2" HEX
HEAD BOLT & NUT
FRAME
UNI-CLAMPS
(1) STOP TAB, 5/16"
WASHER, AND NUT
KOOL HOUSE
FRAME SECTION
ROLL FORM
END BASE
#12-14 x 3/4" SELF
DRILLING SCREW
ROLL FORM
CORNER MOUNT
OPTIONAL END FRAME WITHOUT DOOR
SIX
REV: AC-120529 57086-3
KOOL HOUSE
(4) #12-14 x 3/4" SELF
DRILLING SCREW
1-1/2" VERTICAL