Poly-Tex KOOL HOUSE - Manual (Page 15)

FIGURE 4
WRONG
RIGHT
FIGURE 3
FIGURE 2
When installing poly roof and/or
ends use one layer of wiggle except
on all corners and when joining end
poly and roof poly in the same poly
fastener base. Use two layers of
wiggle wire in these two situations.
(SEE FIGURE 3)
When installing wiggle wire, be sure
to overlap your wiggle wire one
section.
(SEE FIGURE 3)
After the poly fastener base is secured to
your greenhouse frame, install your foam
tape. Do not peel off paper backing.
Next, position your poly over the
greenhouse frame (being sure to have
equal amount of film on all sides) and
install one layer of wiggle wire. Use a
back and forth motion while seating the
wire into the base. (SEE FIGURE 2)
(OPTIONAL)
USE THESE INSTRUCTIONS ONLY FOR DOUBLE POLY APPLICATIONS. FOR SINGLE POLY
APPLICATIONS SEE PAGE TWELVE
After all wiggle wire is installed, cut
remaining wires into 8" to 12" pieces
and use to reinforce all corners.
(SEE FIGURE 4)
DOUBLE POLY INSTALLATION
THIRTEEN
REV: AC-120529 48426-6
KOOL HOUSE