Lincoln Electric IM10046 VRTEX 360 - Manual (Page 16)

A-6 INSTALLATION
VRTEX ® 360
A-6
TABLE & SWING ARM SET-UP:
1. Place counter weights on base.
2. Using the 3/16” (4.8 mm) allen wrench, remove the
two 1/4” x 20 Allen-head screws from the base
assembly.
NOTE: The longer screw is in the top.
3. Insert red post into base assembly aligning the flat
on the pole with the hole.
NOTE: The post will only insert one way.
4. Using the 3/16” (4.8 mm) allen wrench, secure the
post into position by replacing and tightening the
screws.
6. Insert one of the pins into the post at the #6 loca-
tion.
7. From the top, slide the table onto the post letting it
rest on the pin inserted in previous step.
8. Insert the second pin into the post at the #13 posi-
tion.
9. Obtain the swing-arm from the rear of the VRTEX ®
360 by removing the cable ties from the swing arm
and cable. Grey cable should remain connected to
the VRTEX
® 360 (DO NOT CUT THE GREY
CABLE!).
Pins
5. Obtain the three post T pins from the factory pack-
aging of the VRTEX ® 360 .
Swing Arm
Table Post
Table
Weights
Base
Screws