Lincoln Electric IM10046 VRTEX 360 - Manual (Page 13)

STACKING
The VRTEX ® 360 cannot be stacked.
TILTING
Place the VRTEX ® 360 directly on a secure, level sur-
face.
A-3 INSTALLATION
VRTEX ® 360
A-3
HIGH FREQUENCY INTERFERENCE PRO-
TECTION
READ ENTIRE INSTALLATION SECTION BEFORE
STARTING INSTALLATION.
Safety Precautions
------------------------------------------------------------
SELECT SUITABLE LOCATION
The machine will not operate in harsh environments.
It is important that simple preventative measures are
followed in order to assure long life and reliable opera-
tion. This product is for INDOOR USE ONLY.
• Dirt and dust that can be drawn into the machine
should be kept to a minimum. Failure to observe
these precautions can result in excessive operating
temperatures and nuisance shutdown.
• Do not locate where monitor is exposed to direct
sunlight.
• Do not place equipment near radiant heat sources.
• Do not place in a confined space. Allow a minimum
of 3 feet of clearance around machine and stand at
all times. Adequate ventilation is necessary.
• The circuit breaker switch on the rear panel is the
input power disconnect device. Do not position the
equipment so that it is difficult to operate the circuit
breaker.
• Route and protect power cable to minimize exposure
to damage.
• Single or Multi-Outlet surge protector (or Surge
Suppessor) is highly recommended to protect the
machine from voltage spikes going through the input
line.
ENVIRONMENTAL AREA
Keep the machine inside and dry at all times. Do not
place it on wet ground or in puddles. Never place liq-
uids on top of the machine.
ELECTRIC SHOCK can kill.
• Only qualified personnel should per-
form this installation.
• Turn the input power OFF and
unplug the machine from the recep-
tacle before working on this equip-
ment.
• Insulate yourself from the work and ground.
• Always connect the VRTEX
® 360 to a power sup-
ply grounded according to the National Electrical
Code and local codes.
WARNING
CAUTION
USE CAUTION WHEN OPERATING THIS MACHINE
AROUND OTHER EQUIPMENT.
• Large equipment, such as cranes, may interfere
with the operation of this machine.
• This machine may interfere with the operation of
other equipment in work / training area.
• High frequency process, such as TIG machines,
may interfere with the operation of this machine.
• Lift only with equipment of ade-
quate lifting capacity.
• Be sure machine is stable when
lifting.
• Do not operate machine while
suspended or when lifting.
FALLING EQUIPMENT can cause injury.
------------------------------------------------------------------------
WARNING
LIFTING
If lifting the VRTEX
® 360 is required, use two straps, each
rated for 500 pounds (226.8 kg) or more. Do not attempt
to lift the VRTEX
® 360
with accessories attached to it.
STRAPS