Lincoln Electric IM10090 ARC TRACKER - Manual (Page 16)

B-3 OPERATION B-3
RECOMMENDED PROCESSES AND
EQUIPMENT
RECOMMENDED PROCESSES
• DC arc welding circuits only
• Any welding process
• Any welding equipment
PROCESS LIMITATIONS
• Cannot be used with AC arc welding circuits
• 1000 A, 120 V, (maximums)
EQUIPMENT LIMITATIONS
• The weld terminals on the back of the ARC TRACK-
ER™ have a maximum threshold of welding current
which can flow through them. The correct number
and size of welding conductors must be used for
proper cooling. See the installation section for prop-
er connectivity.
• The ARC TRACKER™ has been calibrated before
being shipped from the factory. The Lincoln Electric
Company recommends that end-users of its welding
equipment evaluate the suitability of utilizing this
product in their quality system, determine if periodic
calibration is required and the calibration interval
based upon the criticality of the welding application,
the environment in which the equipment is located,
the level of preventive maintenance and the actual
conditions of use.
• The Ethernet connection gives the ARC TRACK-
ER™ the ability to run Production Monitoring™ with
certain function limitations, such as, no support for
wire feed speed, deposition rate, consumable pack-
age tracking and weldscore.
ARC TRACKER™