Agilent Technologies USB/GPIB Interface Converter 82357A - Manual (Page 51)

Chapter 3 51
Troubleshooting the 82357A
Software Installation Checks
Verify 82357A USB Driver Installation
After installing the Agilent IO Libraries, check for installed driver files.
1 Check for Driver Files. This table lists the USB driver files in their
default directories.
2
Uninstall the Agilent IO Libraries Suite. If the driver files cannot be
found, uninstall the Agilent IO Libraries Suite by going to the Windows
Control Panel, Add or Remove Programs, selecting Agilent IO
Libraries Suite, and clicking
Remove and Next> . Then, follow the
instructions to remove the libraries.
3 Reinstall the Agilent IO Libraries Suite. Insert the CD into the CD-ROM.
Follow the instructions in Chapter 1 - Installing the 82357A to install
the libraries. If you do not have the Automation-Ready CD, you can
download the Agilent IO Libraries Suite from
http://www.agilent.com/find/iolib
‰ If only the FAIL LED remains ON, go to “Hardware Checks”.
‰ If all three LEDs turn ON, go to “Software Configuration Checks”.
‰ If the red FAIL LED still does not turn OFF, contact Agilent.
Windows 2000
Program Files C:\Program Files\Agilent\IO Libraries Suite\drivers\ag357i32.dll
Driver Files C:\Winnt\system32\drivers\agt82357.sys
.inf Files C:\Winnt\inf\agt357.inf
Windows Me/XP
Program Files C:\Program Files\Agilent\IO Libraries Suite\drivers\ag357i3l.dll
Driver Files C:\Windows\system32\drivers\agt82357.sys
.inf Files C:\Windows\inf\agt357.inf
Windows 98 SE
Program Files C:\Program Files\Agilent\IO Libraries Suite\drivers\ag357i3l.dll
Driver Files C:\Windows\system32\drivers\agt82357.sys
.inf Files C:\Windows\inf\agt3579x.inf