3 stand mounting, 4 arm mounting, Figure 5-20: mounting screw location – IEI Integration AFL2-W19A-H61 v1.11 User Manual

Page 85

AFL2-W19A/AB-H61

P a g e 66

5.13.3 S ta n d Mo u n tin g

To mount the AFL2-W19A/AB-H61 using the stand mounting kit, please follow the steps

below.

S te p 1:

Locate the screw holes on the rear of the AFL2-W19A/AB-H61. This is where

the bracket will be attached. (Figure 5-20)

Figure 5-20: Mounting screw location

S te p 2:

Align the bracket with the screw holes.

S te p 3:

To secure the bracket to the AFL2-W19A/AB-H61, insert the retention screws

into the screw holes and tighten them.

S te p 0:

5.13.4 Arm Mo u n tin g

The AFL2-W19A/AB-H61 is VESA (Video Electronics Standards Association) compliant

and can be mounted on an arm with a 100mm interface pad. To mount the

AFL2-W19A/AB-H61 on an arm, please follow the steps below.

S te p 1:

The arm is a separately purchased item. Please correctly mount the arm onto

the surface it uses as a base. To do this, refer to the installation documentation

that came with the mounting arm.