IEI Integration AFL2-W19A-H61 v1.11 - Manual (Page 64)

AFL2-W19A/AB-H61
P a g e 45
4.1 Un pa c kin g
To unpack the flat bezel panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the flat bezel panel PC has
been properly installed. This ensures the screen is protected during the
installation process.
S te p 1: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
S te p 2: Open the external (second) box.
S te p 3: Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
S te p 4: Lift the monitor out of the boxes.
S te p 5: Remove both polystyrene ends, one from each side.
S te p 6: Pull the plastic cover off the flat bezel panel PC.
S te p 7: Make sure all the components listed in the packing list are present. S te p 0:
4.1.1 P a c kin g Lis t
The AFL2-W19A/AB-H61 flat bezel panel PC is shipped with the following components:
Qu a n tity Ite m Im a g e
S ta n d a rd
1 AFL2-W19A/AB-H61 panel PC