IEI Integration PPC-5152-D525 v1.02 - Manual (Page 75)

PPC-5152-D525 Falt-bezel Panel PC
Page 61
Step 6: Grasp the DDR3 memory module by the edges and carefully pull it out of the
socket.
Step 7: Install the new DDR3 memory module by pushing it into the socket at an angle
(
6
Figure 4-2 ).
Step 8: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
6
Figure 4-2 ).
Step 9: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Figure 4-2: DDR SO-DIMM Module Installation
Step 10: Replace the internal aluminum cover and secure it to the chassis using six (6)
retention screws.
Step 11: Replace the back cover and secure it using nine (9) previously removed
retention screws. Step 0:
4.5.2 WLAN Card Replacement
The PPC-5152-D525 has one WLAN card slot. To replace the WLAN card, follow the
instructions below.
Step 1: Follow all anti-static procedures. See Section
6
4.2 .
Step 2: Turn off the power. See Section
6
4.3 .
Step 3: Remove the back cover. See Section
6
4.4 .