IEI Integration IMB-C2160 - Manual (Page 66)

IMB-C2160 Mic ro -ATX Mo th e rb o a rd
P a g e 51
4.3 Ba s ic In s ta lla tio n
WARNING:
A CPU should never be turned on without the specified cooling kit
being installed. If the cooling kit (heat sink and fan) is not properly
installed and the system turned on, permanent damage to the CPU,
IMB-C2160 and other electronic components attached to the system
may be incurred. Running a CPU without a cooling kit may also result
in injury to the user.
The CPU, CPU cooling kit and DIMM are the most critical components of the IMB-C2160.
If one of these component is not installed the IMB-C2160 cannot run.
4.3.1 S o c ke t LGA1155 CP U In s ta lla tio n
WARNING:
CPUs are expensive and sensitive components. When installing the
CPU please be careful not to damage it in anyway. Make sure the CPU
is installed properly and ensure the correct cooling kit is properly
installed.
DO NOT touch the pins at the bottom of the CPU. When handling the
CPU, only hold it on the sides.
To install the CPU, follow the steps below.
S te p 1: Disengage the load lever by pressing the lever down and slightly outwards to
clear the retention tab. Fully open the lever. See Figure 4-1.