3 so-dimm installation, 5 jumper settings – IEI Integration KINO-QM57A User Manual

Page 67

KINO-QM57A Mini-ITX SBC

Page 53

4.4.3 SO-DIMM Installation

To install an SO-DIMM, please follow the steps below and refer to Figure 4-4.

Figure 4-4: SO-DIMM Installation

Step 1:

Locate the SO-DIMM socket. Place the board on an anti-static mat.

Step 2:

Align the SO-DIMM with the socket. Align the notch on the memory with the

notch on the memory socket.

Step 3:

Insert the SO-DIMM. Push the memory in at a 20º angle. (See Figure 4-4)

Step 4:

Seat the SO-DIMM. Gently push downwards and the arms clip into place. (See

Figure 4-4)

4.5 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

Figure 4-5: Jumper Locations