IEI Integration PCISA-945GSE v1.01 - Manual (Page 86)

PCISA-945GSE CPU Card
Page 68
5.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three
metal pins and a small metal clip (often
protected by a plastic cover) that slides over
the pins to connect them. To CLOSE/SHORT
a jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a
jumper.
Jumper Locations
Before the PCISA-945GSE is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the PCISA-945GSE are listed
in Table 5-1.
Description Label Type
AT/ATX power selection ATXCTL1
J_AUTOPWR1
3-pin wafer
2-pin header
CF card setup JCF1 2-pin header
Clear CMOS J_CMOS 3-pin header
COM 2 function select JP1 8-pin header
LCD panel resolution selection J_LCD_TYPE1 8-pin header
LVDS voltage selection J_VLVDS 3-pin header
Table 5-1: Jumpers