IEI Integration PCISA-945GSE v1.01 - Manual (Page 101)

PCISA-945GSE CPU Card
Page 83
Figure 5-11: SATA Power Drive Connection
5.8.8 USB Cable (Dual Port) with Slot Bracket
The PCISA-945GSE is shipped with a dual port USB 2.0 cable. To connect the USB cable
connector, please follow the steps below.
Step 10: Locate the connectors. The locations of the USB connectors are shown in
Chapter 3.
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 11: Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the PCISA-945GSE USB connector.
Step 12: Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the PCISA-945GSE, connect the cable connectors
to the on-board connectors. See Figure 5-12.