IEI Integration ROCKY-3786 v4.0 User Manual

Page 76

IEI

Technology, Corp.

WARNING:

When handling the CPU, only hold it on the sides. DO

NOT touch the pins at the bottom of the CPU.

Step 1:

Inspect the CPU socket. Make sure there are no bent pins and make sure the

socket contacts are free of foreign material. If any debris is found, remove it with

compressed air.

Step 2:

Open the CPU socket lever. Disengage the load lever by pressing the lever

down and slightly outward to clear the retention tab. Rotate the load lever to a

fully open position. (See Figure 4-1)

Step 3:

Orientate the CPU properly. Make sure the IHS (Integrated Heat Sink) side is

facing upward. (See Figure 4-1)

Step 4:

Correctly position the CPU. Match the Pin 1 mark with the cut edge on the CPU

socket. (See Figure 4-1)

Figure 4-1: Install the CPU

Step 5:

Insert the CPU. Gently insert the CPU into the socket. If the CPU pins are

properly aligned, the CPU should slide into the CPU socket smoothly

Step 6:

Close the CPU socket. Re-engage the load lever by pushing it back to its