IEI Integration ROCKY-3786 v4.0 - Manual (Page 172)

172
IEI ® Technology, Corp.
Step 1: Delete RAID Settings. Use the arrow keys to highlight Delete All RAID Setting &
Partition and press E NTER .
Step 2: Confirm delete. The Data on RAID drives will be erased (Y/N) confirm box
appears. Press Y.
Step 0:
E.4.7 Rebuild RAID Array
The Rebuild RAID Array option can rebuild a RAID array if a member of a RAID
configuration should fail. Neither RAID 0 nor JBOD provides data redundancy. The
Rebuild RAID Array option only applies to RAID1 arrays and is applicable when a
member of a RAID1 configuration has failed.
Step 1: Select Rebuild Array. Use the arrow keys to highlight Rebuild RAID Array and
press E NTER . A flashing ‘R’ appears in the list of existing arrays. The source and
destination drives will be displayed.
Step 2: Confirm rebuild array. Press Y to begin the rebuild process. Step 0:
NOTE:
A status bar will indicate the rebuild progress. Rebuild consumes
considerable system resources and the time required for rebuilding a RAID
array may vary depending on the size of stored data, disk drive capacity, and
drive performance.
E.4.8 Select Boot Drive
Step 1: Select the Boot Drive. Use the arrow keys to highlight Select Boot Drive and
press E NTER . A flashing ‘A’ appears at the Drive Menu where the boot drive can
be chosen.
Step 2: Press E NTER . Press E NTER or the space bar to finish the configuration. Step 0: