Win-Holt WHSS-1 - Manual (Page 5)

Film Roll Axle Assembly
4
MODEL: WHSS-1
FILM ROLL AXLE ASSEMBLY INSTRUCTIONS:
1. Install Bearing Block Assembly (A) on the left side of Base, line
up holes and insert Carriage Bolts (B) and tighten using Wing
Nuts (C).
2. Repeat step (1) on right side of Base.
3. Loosen all Wing Nuts (D) on Bearing Blocks on both sides to
loosen top of Bearing Blocks, and then rotate top to expose
Film Roll Axle Slots.
4. Install Film on Film Roll Axle (F), tighten Core Adapter Wing
Nut (G), and insert in slots in the bottom of the Bearing Blocks.
5. Rotate the top of Bearing Block to cover shaft of Film Roll Axle,
and tighten Wing Nuts (D) to the required tension.
New York • Pennsylvania • Georgia • Texas • California
China • India
800-444-3595 www.winholt.com