Win-Holt WHSS-1 - Manual (Page 4)

Loading The Film Axle
3
LOADING THE FILM AXLE:
1. Loosen all Wing Nuts. Swing out right and left Bearing Blocks.
2. Lift out the Axle Assembly. Unscrew Wing End Cap, position Pin
End Cap for correct fi lm width, secure with Pin and 0-Ring.
3. Position the cardboard core of the Film Roll against the taper
of the Pin End Cap. Make certain thatthe fi lm will dispense
from the bottom ofthe roll.
4. Replace Wing End Cap and Screw tightly.
5. Replace Axle and Film onto the Lower Bearing Blocks. Swing
Upper Bearing Blocks back into place. Tighten and adjust Wing
Nuts for desired fi lm tension.
MODEL: WHSS-1
MODEL: WHSS-2
MODEL: WHSC-3
New York • Pennsylvania • Georgia • Texas • California
China • India
800-444-3595 www.winholt.com