Asante Technologies 3500 Series - Manual (Page 28)

28
1. Open the SNMP Configuration Menu by typing n in the Configuration Menu.
2. Type
d to Delete a Trap Receiver. A prompt for the entry of the trap receiver appears.
3. Enter the number of the entry you want to delete (1,2,3, or 4) and press Enter.
The trap receiver is deleted from the SNMP Trap Receivers list.
For further details on using SNMP, see Chapter 6 SNMP Management.
3.7 Port Configuration
The Port Configuration Menu allows you to manually configure each port of the switch for port speed,
duplex, and auto-negotiation. It also provides an overview of the entire system’s port operating status.
To access the Port Configuration Menu, type p in the Configuration Menu. A System Unit Map screen
appears. Type the unit number you wish to configure and press Enter.
System Unit Map
=================
Please select one of the following slots
Slot Description (Unit Type)
---- -------------------------------------------
1 IntraCore 3524 Unit
2 IntraCore 3524 Unit
3
4
5
6
7
8
Enter Unit Number (1 - 8) >
The Basic Port Configuration Menu appears.
IntraCore 3524 Basic Port Configuration Menu Unit Type: [IntraCore 3524 Unit]
Unit: [1] Port: [01]
Operating Status: -------- -------- -------- -K
Auto Negotiation: ******** ******** ******** **
Speed/Duplex: hhhhhhhh hhhhhhhh hhhhhhhh GG
Port Status: Enabled Link Status: Down
Auto-Nego: Enabled[ABCD] Link Speed: N/A
h Help for Legends
t Toggle Port Status Enable/Disable
a Toggle Auto-Negotiation/Manual
l Toggle 10M/100M bps Link Speed
d Toggle Half/Full Duplex
r Restart Auto-Negotiation
v Advanced Port Configuration
g Global Port Configuration
q Return to previous menu
Command>
Select U)nit Nex)t unit Prev) unit S)elect port N)ext port P)rev port