Warner Electric ATT Brakes and Clutches - Manual (Page 3)

3
Warner Electric • 800-825-9050 819-0341
Figure 4
5. Lift out the worn friction material segments.
Assure that the autogap plate, detent ring
and spring remain in place on the clutch units
during this step. (See Figure 5)
Figure 5
6. Insert two new friction material segments.
The recessed holes should be facing away
from the magnet body. (See Figure 6)
Figure 6
7. Attach the new friction material segments to
the brake magnet or clutch rotor with the
screws through the appropriate access holes.
Apply one drop of Loctite
® ‚ (grade AA equiva-
lent) to each screw. (See Figure 7)
Note: Use
only the screws included with the repair kit
since any other screws may damage the
unit. Tighten screws to 18 to 22 inch
pounds torque.
Figure 7
8. Insert the two new armature segments. (See
Figure 8)
Figure 8
9. Attach the new armature segments to the
cast iron carrier with hex head capscrews,
lockwashers and washers. (See Figure 9)
Apply one drop of Loctite
® ‚ (grade AA or
equivalent) to each screw. Clean all hardware
to remove old Loctite‚ and dirt. Tighten to the
appropriate torque for your size unit.