Warner Electric Gen 2 Enclosed Module Option With Cover Plate For Brake Only - Manual

Vented Warner Electric Modules and base
assemblies can be oriented as necessary to keep
contaminant's from entering the open housing
vents.
If an Enclosed Module is required, an optional
Cover Kit (Warner Electric part number
5370-101-082), can be purchased separately to
enclose the open vents in the housing.
Each cover kit includes two (2) vent covers, two
(2) gaskets, four (4) screws and a cover plate to
enclose the open end of the brake when mounted
to the back of the motor. This converts a vented
Module to an enclosed design (non-washdown) as
shown below.
Note: When using this Cover Kit to enclose the
module, the vent covers should be assembled as
the final step.
Gen 2
Enclosed Module Option
With Cover Plate For Brake Only
Installation & Operating Instructions
P-273-7
819-0541
Heat Dissipation Curves
Note: When calculating cycles per minute for
Gen 2 50, 100/180 modules, use the Heat
Dissipation Curves above.