Warner Electric Gen 2 Ceramic Faced Clutch_Brake UniModule UM-50C, UM-180C - Manual (Page 2)

Corresponding
NEMA Frame Sizes
C-Face
UM Old New Shaft Pilot
Size NEMA NEMA Dia. Dia.
50 56 C 48 Y 5/8" 4-1/2"
180 182 C 143 TC 7/8" 4-1/2"
184 C 145 TC
Table 1
The 2030-C UniModules are designed to mount
using a base mounting kit. This allows the
modules to be mounted as a separate drive unit
driven from the prime mover by V-belts, chain
and sprockets, couplings, timing belts and other
standard power transmission components.
(For UniModule size 210-C please refer to
Warner Electric manual P-273-3)
For These UM-C Combinations Use These
Installation Steps:
Install your specific Ceramic UniModule
combination according to the installation steps
specified in the table. Use only those steps
indicated for each combination.
UniModule Clutch/Brake between
C-Face Motor and Reducer
1020-C
UniModule Clutch/Brake
2030-C
Motor Mount Module Clutch/Brake
on a C-Face Motor
1020-C-M
Base Mounted
UniModule Clutch/Brake
2030-C-B
2 Warner Electric • 800-825-9050 P-273-10 • 819-0532
Contents
Mounting to a C-Face Motor . . . . . . . .3
Mounting to a Reducer . . . . . . . . . . . . .4
Installing the Base Mount . . . . . . . . . . .4
Installing the Motor Mount Bracket . . .5
Mounting to Other Power
Transmission Components . . . . . . . .5
Electrical Connections . . . . . . . . . . . . . .6
Troubleshooting-Electrical . . . . . . . . . . .6
Troubleshooting-Mechanical . . . . . . . . .6
Warranty . . . . . . . . . . . . . . . . . . . . . . .BC
Failure to follow these
instructions may result in product damage,
equipment damage, and serious or fatal
injury to personnel.
The equipment covered by
this installation manual must be installed in
accordance with these instructions. Failure
to do so may damage the equipment and
void the warranty.
The ceramic versions of Warner Electric
UniModules are completely assembled
clutch/brake packages for out of box use.
They are engineered for easy installation, while
providing extra long life over standard units.
Technically advanced ceramic friction material
provides exceptional wear resistance and
enhanced performance making Ceramic
UniModule clutch/brakes ideal for high cycle
rate applications.
Ceramic clutch/brake combinations are offered
in two configurations. The "1020-C" has a hub
input and a male shaft output. The "2030-C" has
a male shaft extension for both input and out-
put. These two configurations are offered with
various mounting accessories to make ceramic
friction faced UniModules adaptable to many
power transmission systems.
The 1020-C UniModules are designed to mount
to the face of a C-Face motor as noted in
Table 1.
Mounting to a Motor
Mounting to a Reducer
Electrical Connections
Mounting to other
Power Transmission
Components
Electrical Connections
Mounting to a Motor
Installing the Motor
Mount Bracket
Mounting to other
Power Transmission
Components
Electrical Connections
Installing the Base Mount
Mounting to other
Power Transmission
Components
Electrical Connections