Warner Electric Snap Ring - Manual

Snap Ring
Installation Instructions
P-1429
819-0449
Warner Electric • 800-825-9050 819-0449
Your Warner Electric Pump Clutch is retained
using at least one retaining ring. (See Figure 1)
The design of these retaining rings require they
be installed correctly. Installing the rings incor-
rectly will result in catastrophic failure of the
clutch assembly. It is the responsibility of the
installer to assemble the retaining ring correctly.
1. Find the retaining ring and carefully inspect it
for the location of the bevel. (See Figure 2)
2. Now examine the clutch mounting surfaces
on the pump. There must be a corresponding
groove designed to accept the retaining
rings. The forward edge of the retaining ring
groove will have an inclined surface intended
to mate with the bevel on the retaining ring. If
installed correctly, the ring will fully engage
the groove on the pump and retain the clutch
as intended. (See Figure 3) If the ring is
installed incorrectly, the clutch component
will vibrate loose and cause interference with
mating components or complete separation
of the pump clutch from the pump.
Rotor/Pulley
Assembly
Hub/Armature
Assembly
Field Coil
Assembly
Field Coil Assembly
Snap Ring
Pump Mounting
Rotor/Pulley Assembly
Snap Ring
Figure 1
Bevel
Snap Rings
Rotor or Field
Figure 2
Fully seated
snap ring
Install with beveled face away from compressor
Correct Incorrect
Figure 3
Failure to follow these
instructions may result in product
damage, equipment damage, and
serious or fatal injury to personnel.