Vanguard ATRT-01_01B S3 - Manual (Page 40)

ATRT-01/01B S3 USER’S MANUAL REV 1
36
3.7.2. Saving Test Results to a Test Record
After performing a test, the user is presented the option to save the test results to the unit’s
Flash EEPROM or to a USB Flash Drive. If the test results are not saved immediately after
performing a test, they will still remain in the working memory and can be saved later, as long
as a new test has not been performed and the unit has not been turned off. Follow the steps
below to save the test results from the working memory to a test record (the following
procedure can also be used to re-save a restored test record to a new memory location or to a
USB Flash Drive):
a. Perform a test or restore a test record to the working memory (see section 3.7.3 and
3.7.4), and then start from the “START-UP” menu:
Press the [2] key (SETUP).
b. The following screen will be displayed:
Press the
[4]
key (SAVE/RESTORE RECORD)
c. The following screen will be displayed:
NOTE
Option 5 (COPY TO THUMB DRIVE) will be listed only if a USB Flash drive is
connected to the ATRT.
Press the [2] key (SAVE RECORD).
1. RESTORE RECORD
2. SAVE RECORD
3. RECORD DIRECTORY
4. ERASE RECORD
5. COPY to THUMB DRIVE
1. RECORD ID
2. TEST VOLTAGE
3. PRINT RECORD
4. SAVE/RESTORE RECORD
5. SET TIME
6. SET LANGUAGE
1. TEST TRANSFORMER
2. SETUP
3. CALCULATOR
time: 14:21:34
date: 05/24/11