Vanguard ATRT-01_01B S3 - Manual (Page 30)

ATRT-01/01B S3 USER’S MANUAL REV 1
26
f. The following screen will be displayed:
Press the [1] key (YES) to save the reading.
g. The following screen will be displayed:
Press any key to continue.
NOTE
The above screen will be displayed if there is currently no data in the unit’s
memory buffer. If a test was previously performed or a test record was
restored from Flash EEPROM or from a Flash drive, the following screen will
be displayed instead:
Press the [1] key (APPEND PREV. DATA) to append the data in the unit’s
working memory to the current test results, or press the [2] key (CLEAR PREV.
DATA) to clear any previous data from the unit’s memory buffer and only save
the current test results.
The following screen will then be displayed:
Press any key to continue.
TEST SAVED
PREVIOUS DATA IN BUF
1. APPEND PREV. DATA
2. CLEAR PREV. DATA
TEST SAVED
KEEP THIS READING?
1. YES
2. NO