TREND IQView.._RPM User Manual
TREND Accessories for electrical
1
IQView../RPM Installation Instructions TG200712 Issue 1/F 10/01/07
Important: Retain these instructions
Installation Instructions
IQView../RPM
Rear Panel Mounting Touch Screen Display
1 - 1
IQVIEW/P ANEL Installation Instructions - Template TG200723 Issue 1/A 5/11/03
Installation Instructions - T emplate
IQVIEW/PANEL
Touch Screen Display
Important: Retain these instructions
IQVIEW/P ANEL
Installation Instructions - T emplate
Trend Control Systems Ltd reserves the right to revise this publication from time to time and make changes to the content hereof
without obligation to notify any person of such revisions or changes.
Trend Control Systems Ltd P.O. Box 34 Horsham Sussex RH12 2YF England Tel:+44 (0)1403 211888 Fax:+44 (0)1403 241608 www.trend-controls.com
10 cm
4"
NOTE: Print to size.
Check dimensions below
132 m m (5.2" )
10
3
mm
(4
.06
"
)
display cutout clearance dim ensions
cutout for display
A
A
A
A
A mounting hole centres
VIEW FROM FRONT
2 Storing
60.62 mm (2.39")
234 mm (9.21")
208 mm (8.19")
Dimensions
Requirements
a
H
2
O
0 °C
(32 °F)
+45 °C
(113 °F)
0 %RH
80 %RH
c
1
2
H
2
O
+50 °C
(122 °F)
0
-10 °C
(14 °F)
90 %RH
CONTENTS
1
Unpacking ........................................................................... 1
2
Storage ............................................................................... 1
3
Installation Instructions ...................................................... 1
3.1 Installation - Mounting ......................................................... 1
3.2 Installation - Configuration ................................................. 6
4
Disposal ............................................................................ 10
5
End User Licence Agreement .......................................... 11
IQView../RPM
Installation Instructions
TG200712
1 Unpacking
3 Installation Instructions
3.1 Installation - Mounting
Protection: IP54, NEMA3
(if correctly fitted in panel)
The unit is UL rated as 'UL916, open energy
management equipment'
cable and terminal access
b
65 mm (2.56")
d
!
WARNING
Do not attempt to open the unit. Failure to
comply may cause damage to the unit
IQView Manual
TE200719
IQView../RPM Template
TG200723
It is recommended that the installation should
comply with the HSE Memorandum of Guidance
on Electricity at Work Regulations 1989.
For USA install equipment in accordance with
National Electric Code