TREND iQView4 - Manual

1 Unpacking
2 Storing
Dimensions
1
Mounting requirements
2
It is recommended that the installation should
comply with the HSE Memorandum of Guidance
on Electricity at Work Regulations 1989.
For USA install equipment in accordance with
National Electric Code
contentS
1. Unpacking .....................................................................1
2. Storing ...........................................................................1
3. Installation Instructions .................................................1
3.1. Installation - Mounting ...................................................1
3.2 Installation - Configuration ............................................4
4. End User Licence Agreement .......................................6
5. Removal of Bezel ..........................................................7
6. Disposal .........................................................................7
IQView4
Installation Instructions
TG201038
IQView4 Manual
TE201041
IQView4 Template
TG201037
IQView 4 IQview 4
ㅠ ǜ   Ҟ
ǡ
IQview 4 IQview 4 Touch Screen Display
Ҝ Қ_ ¥ Қ Қ ҝ ҝ Қ ҝ ǣ ǟ Ǫ Ǫ � � � � � � � � � �        ǡ ǣ ǚ ǚ Қ Қ Қ Қ Қ Қ Қ Қ � � � � � � � � ǟ Ǣ Ǣ ǝ ǝ ǯ Ǣ Ǣ Ǣ ǯ ǯ Ǜ ҝ ҝ ҝ ҝ ҝ ҝ   Ѻ Ҡ Ҡ ǟ ǟ Ҥ
ņ ņ ! қ Қ ǜ ǜ     в ң
Ǟ
ҟ
ǯ
Ǚ ǯ Ǚǯ
Ҟ Cut out 
ҡ Ҟ
H O
2
+50 °C
(122 °F)
0 -10 °C
(14 °F)
90 %RH
H O
2
0 °C
(32 °F)
+45 °C
(113 °F)
0 %RH 80 %RH
c
protection: ip50
(if correctly fitted in panel)
The unit is UL rated as ‘UL916 listed open energy
management equipment’
a
b
d
3 inStallation
3.1 installation Mounting
185 mm (7.3”)
7.5 mm (0.3”)
32.5 mm (1.3”)
15
5 m
m (
6.
1”
)
EMC (EN61326-1: 2006) Emissions: Class A
Warning: This is a class A product. In a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures.
IQView4 Installation Instructions TG201038 Issue 1, 12/02/2009 1
installation instructions
iQView4
touch Screen Display
important: retain these instructions
!
WARNING
Do not attempt to open the unit. Failure to
comply may cause damage to the unit