TREND EM3_CT_N - Manual (Page 11)

Programming
PowerRail303 Page 9
3.1.8 KW Demand Period Programming
Demand Setup
PEr 30
This sets the time, in minutes, over which kW Demand measurements are averaged. This is
sometimes referred to as the sliding window or rolling average period.
Press or to increase/decrease the kW Demand period.
Press when the desired value is set to move to the next parameter.
3.1.9 Baud Rate Programming
Setup
br 9600
This sets the Baud Rate of the serial communications if the Modbus option is fitted at the factory.
Press or to select the desired baud rate from a table
Press when the desired value is set to move to the next parameter.
3.1.10 Modbus ID Programming
Setup
Addr 247
This sets the meters unique communications network ID (Modbus address) if the Modbus option is
fitted at the factory.
Press or to increase/decrease the value.
Press when the desired value is set to complete programming.
Setup
Storing
The programmed values are saved to non-volatile memory which is secure in the event of a loss of
auxiliary power to the meter.