T/pi/160 installation instructions, Installation, Disposal – TREND T_PI_160 User Manual
Page 4
4
T/PI/160 PRT Immersion Temperature Sensor Installation Instructions TG100310A Issue 3/C 25/06/07
T/PI/160
Installation Instructions
Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Ecublens, Route
du Bois 37,Switzerland by its Authorized Representative, Trend Control Systems Limited.
Trend Control Systems Limited reserves the right to revise this publication from time to time and make changes to the content
hereof without obligation to notify any person of such revisions or changes.
Trend Control Systems Limited
P.O. Box 34, Horsham, West Sussex, RH12 2YF, UK. Tel:+44 (0)1403 211888 Fax:+44 (0)1403 241608 www.trend-controls.com
Trend Control Systems USA
6670 185th Avenue NE, Redmond, Washington 98052, USA. Tel: (425)867-3900, Fax: (425)869-8445 www.trend-controls.com
WEEE Directive :
At the end of their useful life
the packaging and product,
should be disposed of by a
suitable recycling centre.
Do not dispose of with normal household
waste. Do not burn.
Replace lid
11
INSTALLATION
(Continued)
DISPOSAL
a
b
Note that IP67 (NEMA6) rating is only achieved if the sensor is correctly installed with cable or conduit connection fully
tightened.
Configure IQ
12
I Q
IQ Configuration Manual 90-1533
I Q
or
It is recommended to use SET (Software Tool) for the setting of the sensor type module. For all IQ2 series controllers with
firmware version 2.1 or greater, or IQ3 series controllers, the following SET Unique Sensor Reference should be used:
PRT Sensor -10+160 (°C)
PRT Sensor +14+320 (°F)
Alternatively set scaling mode to 5 (characterise) and enter scaling manually as defined in table below. Note that for IQ3
the scaling mode and exponent do not need to be set up.
For all other IQ controllers see Sensor Scaling Reference Card TB100521A
MANUFACTURED IN EU
TREND CONTROL SYSTEMS
LTD UK
T/PI/160
Δ T
IQ
Set up IQ sensor type
13
Y
e
p
y
t
t
u
p
n
i
)
t
n
e
r
r
u
c
(
2
E
t
n
e
n
o
p
x
E
3
s
t
i
n
U
C
°
F
°
U
r
e
p
p
U
0
6
1
0
2
3
L
r
e
w
o
L
0
1
-
4
1
P
s
t
n
i
o
P
2
2
x
x
I
x
O
x
O
1
4
0
1
-
4
1
2
0
2
0
6
1
0
2
3
Test system
14
PRT Sensor (-10 °C +160 °C, +14 °F +320 °F)