Teledyne LeCroy WaveStation 3000 Operators Manual - Manual (Page 36)

WaveStation 3000 Function and Arbitrary Waveform Generator
Restoring the Default Settings
To restore the WaveStation to the factory default settings (shown in the table below):
1. Press the Utility function button.
2. Press the More softkey, then press System.
3. Press Set to Default. After a moment, the screen will blink and reset to the CH1:Sine wave parameter
menu.
SubSystem & Parameter Default Values
Output
Function Sine Wave
Frequency 1 kHz
Amplitude/Offset 100 mVpp/0 V DC
Phase 0°
Terminals High Z
Modulation
Carrier 1 kHz Sine Wave
Modulating 100 Hz Sine Wave
AM Depth 100％
FM Deviation 500 Hz
Key Freq 100 Hz
FSK Hop Frequency 1 MHz
Phase Deviation 180°
Sweep
Start/Stop Frequency 100 Hz/1.9 kHz
Sweep Time 1 S
Trig Out Off
Mode Linear
Direction Up
Burst
Period 10 ms
Phase 0°
Count 1 Cycle
Trig Off
Trigger
Source Internal
30 922869 Rev B