Teledyne LeCroy WaveStation 3000 Operators Manual - Manual (Page 19)

Operator's Manual
3. Adjust parameters as necessary using either the Adjustment knob or the numeric keypad.
For all waveforms except Noise, adjust the values for:
l
Frequency or Period.
l
Amplitude and Offset, or absolute HighLevel and LowLevel of voltage.
For Sine waves, also adjust Phase.
For Square waves, also adjust:
l
Phase
l
DutyCycle, entered as the percentage of the High Level taking up the whole period.
For Ramp waves, also adjust Symmetry.
For Pulse waves, also adjust:
l
Width or Duty Cycle
l
Rise(ing Edge) or Fall(ing Edge)
l
Delay
For Noise waves, adjust:
l
Stdev
l
Mean
4. When all parameters are configured, press the appropriate Output button to output the waveform, or go on
to apply Modulation , Sweep , or Burst signal conditioning before outputting.
NOTE: Noise waves cannot be modulated or swept. Pulse waves cannot be swept.
S EE A LSO :
Generating DC Waveforms
Generating Arbitrary Waveforms
Recalling Stored Waveforms
922869 Rev B 13