Teledyne LeCroy WaveStation 3000 Operators Manual - Manual (Page 20)

WaveStation 3000 Function and Arbitrary Waveform Generator
Generating a DC Waveform
DC waveforms cannot be conditioned using Mod(ulate), Sweep, or Burst.
1. Choose your output channel by pressing the Ch1/Ch2 function button until the correct tab is active on the
display.
NOTE: WaveStation defaults to the Channel 1 tab and Waveform menu whenever you power on, although
you can
change this setting on the Utility menu. If Channel 1 is correct, skip to Step 2.
2. Press the Waveform function button to open the Waveform menu, then press the More 1 of 2 softkey.
3. Press the DC softkey.
4. Enter the DC Offset value.
5. Press the appropriate Output button to output the waveform.
S EE A LSO :
Generating Basic Waveforms
Generating Arbitrary Waveforms
Recalling Stored Waveforms
14 922869 Rev B