Teledyne LeCroy WaveLink Differential Probe Series (8-13 GHz) - Manual (Page 58)

WaveLink Medium-Bandwidth (8-13 GHz) Differential Probe
European Contact:
Teledyne LeCroy Europe GmbH
Waldhofer Str 104
D-69123 Heidelberg
Germany
Tel: (49) 6221 82700
A USTRALIA & N EW Z EALAND D ECLARATION O F C ONFORMITY —EMC
The probe complies with the EMC provision of the Radio Communications Act per the following
standards, in accordance with requirements imposed by Australian Communication and Media
Authority (ACMA):
E55011/A1:2010 Radiated and Conducted Emissions, Group 1, Class A, in accordance with
EN61326-1:2013 and EN61326-2-1:2013.
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC D ECLARATION O F C ONFORMITY - L OW -V OLTAGE
The product meets the intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61010-031:2002/A1:2008 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 031: Safety requirements for hand-held probe assemblies for
electrical measurement and test.
l
Measurement Category III (CAT III), for measurements performed in the building installation.
l
Measurement Category II (CAT II), for measurements performed on circuits directly
connected to the low-voltage installation.
l
Measurement Category I (CAT I), for measurements performed on circuits not directly
connected to mains.
l
Pollution Degree 2, operating environment where normally only dry non-conductive pollution
occurs. Conductivity caused by temporary condensation should be expected.
52 924234-00