Teledyne LeCroy AP015 - Manual (Page 9)

Operator’s Manual
922254-00 Rev A 5
Table 1. List of Required Equipment
Description Minimum Requirements Test Equipment Examples
Wide Band oscilloscope Minimum 200 MHz bandwidth
ProBus interface equipped
Software Version 7.6.0 or
greater Teledyne LeCroy LT322
Teledyne LeCroy X-Stream
scope with AP-1M Hi-Z
adapter
Digital Multimeter
(2 required) DC: 0.1% accuracy 5.5 digit
resolution with Null capability
(referenced measurements) Agilent Technologies 34401A
Fluke 8842A-09
Keithley 2001
Leveled Sine Wave
Generator Relative output level accurate
to ±0.3 dB into 50
Ω
1 to 100 MHz frequency
range Output adjustable to 18
dBm
Tegam SG503 with TM
series mainframe and
matching output cable.
A semiautomatic software
leveled signal source
calibrated with a power
meter may be substituted.
DC Power Supply Output adjustable to > 6 V at
1 A Agilent Technologies
E3610A
Calibration Fixture,
50 Turn Loop 50 Turn loop in series with 0.5
Ω ±0.2% resistor with sense
terminals Teledyne LeCroy CP015-
CF02
Calibration Fixture,
High Speed Shunt 50
Ω Termination into single
turn loop.
VSWR < 1.25: 1 DC – 50
MHz
Teledyne LeCroy CP015-
CF01
Calibration Fixture ProBus Extension Cable Teledyne LeCroy PROBUS-
CF01
BNC Adapter, T Male-to-Dual-Female Pomona 3285
BNC coaxial cable Male-Male BNC, 50 Ω, 36” Pomona 5697-36
Banana Plug adapter BNC Female-to-Banana Plug Pomona 1269
Patch Cables
(4 required) Male Banana-to-Male
Banana, 12” Pomona B-12-0 (black)
Pomona B-12-2 (red)