Teledyne LeCroy AP015 - Manual (Page 18)

ADP015 Current Probe
14 922254-00 Rev A
Australia / New Zealand Contacts:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC D ECLARATION OF C ONFORMITY
–
L OW V OLTAGE
The probe meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the
European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 1: General requirements
EN 61010-2:032:2012 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 032: Particular requirements for hand-held and hand-
manipulated current sensors for electrical test and measurement
Environmental Compliance
E ND -O F -L IFE H ANDLING
The probe is marked with this symbol to indicate that it complies with
the applicable European Union requirements to Directives 2002/96/EC
and 2006/66/EC on Waste Electrical and Electronic Equipment (WEEE)
and Batteries.
The probe is subject to disposal and recycling regulations that vary by
country and region. Many countries prohibit the disposal of waste
electronic equipment in standard waste receptacles. For more
information about proper disposal and recycling of your Teledyne LeCroy
product, please visit teledynelecroy.com/recycle.
R ESTRICTION OF H AZARDOUS S UBSTANCES (R O HS)
The probe conforms to 2011/65/EU RoHS2 Directive based on the fact that it is classified
as Industrial Monitoring and Control Instrument (per Article 3, Paragraph 24) and these
product(s) & associated accessories are exempt from RoHS compliance until 22 July 2017
(per Article 4, Paragraph 3).