Teledyne LeCroy AP015 - Manual (Page 6)

ADP015 Current Probe
2 922254-00 Rev A
Observe all terminal ratings. To avoid electric shock or fire, do not use the
probe above the current & voltage limits shown on the probe as well as all
accessories.
Do not remove probe casing. Removing the probe’s case or touching exposed
connections may result in electric shock.
Use indoors only.
Use only within operational environment listed. Do not use in wet or explosive
atmospheres.
Keep product surfaces clean and dry. Clean with a cloth moistened in water or
alcohol. Do not submerge instrument. Do not use harsh or abrasive cleansers.
Do not operate with suspected failures. Do not use the probe if any part is
damaged. Cease operation immediately and sequester the probe from
inadvertent use.
WARNING. To avoid risk of electric shock, keep your fingers behind
the finger guard when locking and unlocking the probe slider. Keep
the probe cable away from the circuits being measured. Use only the
specified accessories.
WARNING. The probe is classified as a Type D current sensor per
EN61010-032 safety standard. Use of the probe is restricted to
insulated conductors or limited energy circuit conductors. Any use of
the probe in a manner not specified by the manufacturer may impair
the probe’s safety protection.
Operating Environment
The accessory is intended for indoor use and should be operated in a clean, dry
environment. Before using this product, ensure that its operating environment is
maintained within these parameters:
Temperature: 0 to 40 °C
Humidity: 80% maximum up to 31 °C
Altitude: 2000 m maximum