Teledyne LeCroy Zi Oscilloscope Rackmount - Manual (Page 2)

Instructions
Remove Plastic Covers
Prepare your oscilloscope for Rackmount installation by removing the back, top, and side covers in the
order shown below. Throughout these procedures, "left" and "right" refer to your left and right when fac-
ing the front of the oscilloscope.
Required Tools
Use the provided tools to remove the covers and metal wrap.
T10 Torx Driver 3mm Allen Key 2.5mm T-handled,
9" long Allen Key
T25 T Handle Torx Driver
922291-00 Rev A 2