LevelOne FCS-1091 - Manual (Page 31)

27
Motion Detection Alerts
The Motion Detection feature can generate an Alert when motion is detected.
The FCS-1091/WCS-1090 will compare consecutive frames to detect changes caused
by the movement of large objects.
But the motion detector can also be triggered by:
• Sudden changes in the level of available light
• Movement of the camera itself.
Try to avoid these situations. The motion detection feature works best in locations
where there is good steady illumination, and the camera is mounted securely.
To Use Motion Detection Alerts
Using the Web-based interface on the FCS-1091/WCS-1090, select the Motion
Detection screen, then configure this screen as described below.
Figure 12: Motion Detection
1. Enable the Motion Detection feature.
2. Set the areas of the video image to be examined for movement. You can define up
to 4 areas, and set the motion threshold individually for each area.
3. If using a schedule, define the desired schedule in Event Trigger screen.
4. Save your changes.
5. Select the Event Trigger screen to have alerts sent
• Enable
Trigger Event and check the box of Motion Detection.