KB Electronics KBVF-23P - Manual (Page 23)

5.1 Removing the Finger-Safe Cover – The Finger-Safe Cover may have to be removed before
wiring the drive or setting selectable jumpers. All trimpots can be readjusted with the Finger-
Safe Cover installed. Notice the orientation of the Finger-Safe Cover before removing it.
Note: The Finger-Safe Cover (except that of the KBVF-21D) is designed with a removable
panel (on the trimpots side) which must be removed for installation of optional accessories
SIVFR Signal Isolator and Run/Fault Relay (Part No. 9597) or Multi-Speed Board (Part No.
9503). Complete instructions are provided with the accessories.
Model KBVF-21D – Designed with three “push-ins” (instead of retainer clips) located where
the Finger-Safe Cover aligns with the base. To remove the cover, gently press at the three
push-ins until the cover disengages from the base.
Models KBVF-22D, 13, 23, 23D, 23P 14, 24, 24D, 24P, 26D – To remove the Finger-Safe
Cover, gently lift up on the four retainer clips until the cover disengages from the base. See
Figures 2B and 3A, on pages 17 and 18.
Note: On Model KBVF-26D, the inner bus capacitor support bracket should not be removed.
5.2 Installing the Finger-Safe Cover – To install the Finger-Safe Cover, be sure to properly align
the retainer clips or push-ins. Gently push the Finger-Safe Cover onto the base until the
retainer clips or push-ins are fully engaged with the base.
6 SETTING SELECTABLE JUMPERS
The drive has customer selectable jumpers which must be set before the drive can be used. For the
location of jumpers, see Figure 4, on page 20.
23