IAI America DS-S-P1 - Manual (Page 14)

Page 12
3 Parameter Window
3.2 Serial I/O Parameters
 From the menu, select Parameter →
Serial I/O
→
Channel 1 or Channel 2.
‚ The Serial I/O Parameter window opens.
Select the appropriate parameter, mark the correct value for the communication target, then set the TimeOut.
ƒ After entering corrections, click OK and the serial I/O parameter write window opens. Click Yes to write the
changes to the controller. Click Cancel to end the operation without saving changes.
It is necessary to reset the controller to make the parameter changes effective.