Gilderfluke&Co 16 Bit CD-Quality Digital Audio Systems User Manual
Page 80

¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥
"?" (HALF-MASK) (FULL-MASK)
Mute Mask:
This command usually comes from the PA MASTER to a AB/DR-3000. It is followed by an eight bit half-
mute mask and an eight bit full-mute mask. Any bits on these two masks which match enabled full and
half mute zones will cause the repeater to set its output level as needed.
EXAMPLE: to mute zone 1, 5 and 6, and half mute zone 3, 4, and 8:
? 8 C 3 1
¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥
"[" (PA ZONE) (PA STATION) (TRUNK#)
PA Command:
This command usually comes from the PA MASTER to a DR-3000 which is part of the PA system. AB-
3000s, having no Digital Audio Bus, canÕt respond properly to PA requests. They will be half-muted if they
think they are responding to a PA request.
This command opens the TRUNK# for each valid request for a PA ZONE. The only PA ZONES which
any DR-3000 will respond to are those which have been enabled on the Main Configuration Menu. If a
higher priority PA request comes in than is already being serviced, it will be honored. If a lower priority PA
request comes in, it will be ignored by the DR-3000.
EXAMPLE: if a PA request comes in from PA STATION 55 to access PA zone AA, with the audio feed
to be found on trunk line 3:
[ A A 5 5 3
¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥
"]" (TRUNK#)
Clear PA Request:
This command usually comes from the PA MASTER to a DR-3000 that is part of the PA system. AB-
3000s, having no Digital Audio Bus, canÕt respond properly to PA requests.
This command is used to clear PA requests on the AB/DR-3000s. When a valid PA request comes in to
any DR-3000, it opens up the appropriate PA TRUNK LINE to feed the audio from the PA STATION to the
DR-3000. This command clears the PA request by turning off the TRUNK# of the PA request. In clearing
the PA request, it allows the mute level to return to whatever it should be.
EXAMPLE: to clear any PA requests which used trunk line 3:
] 3
G
ILDERFLUKE
& C
O
. ¥ 205 S
OUTH
F
LOWER
S
T
. ¥ B
URBANK
, C
ALIF
. 91502-2102 ¥ 818/840-9484 ¥
FAX
818/840-9485
72 of 92