Ab-3000 – Gilderfluke&Co 16 Bit CD-Quality Digital Audio Systems User Manual
Page 26

pin #
COLOR
SIGNAL NAME:
(left)
1
WHITE
signal ground
2
BLACK
- serial data OUT from AB/DR-3000
3
RED
+ serial data OUT from AB/DR-3000
4
GREEN
- serial data IN to AB/DR-3000
5
YELLOW
+ serial data IN to AB/DR-3000
(right)
6
BLUE
signal ground
The proper data format, and pinouts for connecting this plug to a PC or Macintosh computer are in
the section of the manual on Serial Port Commands.
AB-3000:
a
b
c
d
f
k
h
Earth Ground
+ DMX Input
- DMX Input
Analog Input 1
Ground
SMPTE out (-1, +6)/in (-2, +7), Status
outs (-3, +8 ,+5), AES/EBU out (-4, +9)
1/4 J-6
Input
RS-422 Serial Data in/out
Analog Input 2
Line Out
(LEFT)
R-
T+
S
gnd
Amp
}
Balanced Output
T+ S
gnd Amp
}
Unbalanced Output
Line Out
(RIGHT)
R-
T+
S
gnd
Amp
}
Balanced Output
T+
S
gnd Amp
}
Unbalanced Output
c) 1/4 J6 In: Ten position enclosed header compatible with IDS-10 connectors. There is one of
these connectors for each slot in the card cage.
SUPPLY (not used)
+
(Brown) PIN #1
(red) PIN #2
(orange) PIN #3
(yellow) PIN #4
(green) PIN #5
(blue) PIN #6
(violet) PIN #7
(grey) PIN #8
(white) PIN #9
(black) PIN #10
GROUND (not used)
DATA BIT 7
DATA BIT 6
DATA BIT 5
DATA BIT 4
DATA BIT 3
DATA BIT 2
DATA BIT 1
DATA BIT 0
+ 5 to 24 VDC SUPPLY
GROUND
DATA BIT 7
DATA BIT 6
DATA BIT 5
DATA BIT 4
DATA BIT 3
DATA BIT 2
DATA BIT 1
DATA BIT 0
Internal Power
External Power
(Brown) PIN #1
(red) PIN #2
(orange) PIN #3
(yellow) PIN #4
(green) PIN #5
(blue) PIN #6
(violet) PIN #7
(grey) PIN #8
(white) PIN #9
(black) PIN #10
A CC-3004 has four for these connectors on it, while the CC-3016 has sixteen. This input
connector uses the standard Ô1/4 J6Õ pinout used in all the Animation Control Systems manu-
factured by Gilderfluke & Company. All eight inputs are optically isolated from the AB/DR-
3000, and so an external source of power is needed to run this input
17
. The current draw is
less than sixteen ma. per input, so a small wall mounted DC power supply will be sufficient to
drive it. The PS-200 Power Supplies have a 24 VDC output on them that can be used to power
G
ILDERFLUKE
& C
O
. ¥ 205 S
OUTH
F
LOWER
S
T
. ¥ B
URBANK
, C
ALIF
. 91502-2102 ¥ 818/840-9484 ¥
FAX
818/840-9485
18 of 92
17
The AB-3000 has a jumper option of supplying power to the 1/4 J6 input from the AB-3000Õs power
supply. If this option is used, then simple switch closures can be used on these inputs.